Cell Pipe 7130 Modem Setup:

Connect modem to power supply, use the included phone cable (it is specially designed for high speed DSL, do not use your own personal phone cables).  Connect the Ethernet Cable to the Lan 1 port on the modem and the other end into your computer.  Wait 30 seconds for your computer to connect with the modem, then open your browser (Internet Explorer, FireFox, Safari, or Chrome) and tyoe 192.168.2.1 in the internet address bar.  If a pop up appears, then use admin for both the username and password.  You should then see the screen below:

 

 

Click on the Wan Setting link on the left side of the screen, it will bring you to the following page below.  Click Next.

 

Here you enter your username and password, overriding the defaults in the fields, and click Apply changes.  Do not change anything else.  The modem will go through a reboot to save the settings.

To setup the the WiFi Settings, click wireless on the left hand side, and you will see the screen below.  Then change the SSID to the name you want your wireless network show up as (such as Auracom.net or SmithFamily).  Then enter the password you want to use in the preshared key.  Must be 10 characters.  Click save.

It is always good to reboot your modem after making configuration changes.  To do so, click the Reboot Gateway link on the left side near the bottom.